JLG X500AJ Operator Manual - Manual (Page 140)

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
6-30 – JLG Lift – 3121636
Errors Menu
Indicates the agreement (OK) or not (FAULT) status of the
sensors that have a double control.
The sensors are listed on different screens use:
1 - PREV - access the previous input
2 - NEXT - access the successive input
9 - ESC - escape from the INPUT menu
If the OK symbol appears at the side of the sensor it means
that the two elements of the same sensor sent identical
information.
If the FAULT symbol appears at the side of the sensor it
means that the two elements of the same sensor sent incon-
sistent information.
The last page of the error menu describes the error code
relating to the battery charger system, inverter or battery
pack. (See “Lithium-Ion Machine Fault Codes” on page 6-34.)
Errors are indicated by the “spanner” icon in
position 7 on the remote control display (See
“Platform/Remote Control Station LCD Dis-
play” on page 3-11.).
If there are operating problems with the machine and the
“spanner” icon is shown on the display, do not operate
machine until repaired by a JLG factory trained technician.
Working Hours Menu
Indicates the number of machine working hours.
Set-up Menu
The items in this menu cannot normally be accessed.
Joystick Menu
Displays the signal that each individual Joystick sends to the
main board.