JLG X500AJ Operator Manual - Manual (Page 89)

SECTION 5 - EMERGENCY PROCEDURES
3121636 – JLG Lift – 5-1
SECTION 5. EMERGENCY PROCEDURES
5.1 GENERAL
This section explains the steps to be taken in case of an
emergency situation while operating.
5.2 INCIDENT NOTIFICATION
JLG Industries, Inc. must be notified immediately of any
incident involving a JLG product. Even if no injury or
property damage is evident, the factory should be con-
tacted by telephone and provided with all necessary
details.
In USA -
JLG Phone:
877-JLG-SAFE (554-7233)
(8am till 4:45pm EST)
Outside USA: 240-420-2661
E-mail: [email protected]
Failure to notify the manufacturer of an incident involv-
ing a JLG Industries product within 48 hours of such an
occurrence may void any warranty consideration on
that particular machine.
FOLLOWING ANY ACCIDENT, THOROUGHLY INSPECT THE MACHINE AND
TEST ALL FUNCTIONS FIRST FROM THE GROUND CONTROLS, THEN FROM
THE PLATFORM CONTROLS. DO NOT LIFT ABOVE 10 FT. (3M) UNTIL YOU
ARE SURE THAT ALL DAMAGE HAS BEEN REPAIRED, IF REQUIRED, AND
THAT ALL CONTROLS ARE OPERATING CORRECTLY.
5.3 EMERGENCY OPERATION
Power Main Cut-Off Switch Location
A battery cut-off switch - RED handle (photo shows power
OFF) is located on the outside of the battery/electrical box
tray at the left front of the machine just behind the outrigger
mount. When switched off - handle turn all the way in direc-
tion of arrow - all electrical power to the machine is shut
down.
Gas/Diesel/AC-Electric Lithium-Ion-Electric