JLG X500AJ Operator Manual - Manual (Page 69)

SECTION 4 - MACHINE OPERATION
3121636 – JLG Lift – 4-19
4.8 Platform Removal/Installation
The platform may only be removed to allow passage
through areas measuring a minimum of 39 in. (99cm).
NOTE: If the platform is removed only track movement is
allowed.
Platform Removal
1. Remove the platform/remote control box from the
mounting support.
2. Loosen and remove the aluminum caps that
secure the platform to the jib platform mounting
posts.
3. Lift the platform off the mounting posts in an
upward direction. Place platform aside for later
installation.
Platform Installation
1. Lift the platform and align the platform mounts
with the jib mounting posts and lower until
seated.
2. Secure the platform to the jib mounting posts with
the aluminum threaded caps. Do not overtighten.
3. Re-install the platform/remote control box into the
mounting support on the platform.