JLG 1230ES Operator Manual - Manual (Page 13)

SECTION 1 - SAFETY PRECAUTIONS
3121221 – JLG Lift – 1-3
• Ensure that the ground conditions are adequate to support
the maximum tire load indicated on the tire load decals
located on the chassis adjacent to each wheel.
• Do not operate the machine when wind conditions exceed
28 mph (ANSI/CSA SPEC) /(CE/AUST SPEC) - Indoor Use
Only.
• This machine can be operated in nominal ambient temper-
atures of 0
o
F to 104
o
F (-20
o
C to 40
o
C). Consult JLG to opti-
mize operation outside of this temperature range.
Machine Inspection
• Do not operate this machine until the inspections and func-
tional checks have been performed as specified in Section 2
of this manual.
• Do not operate this machine until it has been serviced and
maintained according to the maintenance and inspection
requirements as specified in the machine’s Service and
Maintenance Manual.
• Ensure all safety devices are operating properly. Modifica-
tion of these devices is a safety violation.
MODIFICATION OR ALTERATION OF AN AERIAL WORK PLATFORM SHALL BE
MADE ONLY WITH PRIOR WRITTEN PERMISSION FROM THE MANUFACTURER
• Do not operate any machine on which the safety or instruc-
tion placards or decals are missing or illegible.
• Check the machine for modifications to original compo-
nents. Ensure that any modifications have been approved
by JLG.
• Avoid accumulation of debris on platform deck. Keep mud,
oil, grease, and other slippery substances from footwear
and platform deck.