JLG 1230ES Operator Manual - Manual (Page 74)

SECTION 6 - GENERAL SPECIFICATIONS AND OPERATOR MAINTENANCE
6-10 – JLG Lift – 3121221
3. Tightening of the lug nuts should be done in stages. Fol-
lowing the recommended sequence, tighten lug nuts
per wheel torque.
4. Wheel lug nuts should be torqued after the first 50
hours of operation and after each wheel removal. Check
torque every 3 months or 150 hours of operation.
6.1 SUPPLEMENTAL INFORMATION
The following information is provided in accordance with the
requirements of the European Machinery Directive 2006/42/EC
and is only applicable to CE machines.
For electric powered machines, the equivalent continuous A-
Weighted sound pressure level at the work platform is less than
70dB(A).
For combustion engine powered machines, guaranteed Sound
Power Level (LWA) per European Directive 2000/ 14/EC (Noise
Emission in the Environment by Equipment for Use Outdoors)
based on test methods in accordance with Annex III, Part B,
Method 1 and 0 of the directive, is 109 dB.
The vibration total value to which the hand-arm system is sub-
jected does not exceed 2,5 m/s2. The highest root mean square
value of weighted acceleration to which the whole body is sub-
jected does not exceed 0,5 m/s2.
Table 6-11. Wheel Torque Chart
TORQUE SEQUENCE
1st Stage 2nd Stage 3rd Stage
20-30 ft lbs
(28 - 42 Nm)
65-80 ft lbs
(91 - 112 Nm)
105 -120 ft lbs
(142 - 163 Nm)