JLG 1230ES Operator Manual - Manual (Page 46)

SECTION 4 - MACHINE OPERATION
4-4 – JLG Lift – 3121221
4.5 AC INVERTER OPERATION (OPTION)
NOTE: The inverter automatically turns to OFF if it has not
detected any AC loads for 2 hours, or if the loads are so
small the unit cannot detect them, such as a cell phone
charger. To continue inverter operation after an auto-
matic shut-down, cycle the inverter ON/OFF toggle switch
to OFF then back to ON.
1. The AC inverter ON/OFF toggle switch (1) is located
on the lower rear panel (2) of the machine.
2. When the toggle switch is set to the ON position this
will allow AC current from the inverter to flow to the
AC receptacle box in the platform.
NOTE: Connect devices one at a time to the AC receptacle box.
Do not connect to many high-surge devices at once.
3. To turn off the AC current to the platform AC recepta-
cle box, set the inverter toggle switch to the OFF posi-
tion.
NOTE: Further General and Troubleshooting information about
the Inverter/Charger can be found in the manufacturers
Owner’s Guide included in the manual storage box
mounted on the machine.
Figure 4-2. Location of AC Inverter ON/OFF - Toggle Switch
1 2
ON
OFF