JLG 1230ES Operator Manual - Manual (Page 38)

SECTION 3 - MACHINE CONTROLS AND INDICATORS
3-10 – JLG Lift – 3121221
1. System Distress Indicator - This indicator will light up
with a fault flash code that indicate where a problem
within the system exists.
2. Battery Discharge Indicator (BDI) - This set of lights
is designed to let the operator know the condition of
the batteries.
3. Tilt Indicator Warning Light and Alarm - A red warn-
ing light on the control panel illuminates and an audi-
ble alarm sounds when the chassis is at or beyond the
permitted amount of slope.
IF THE TILT INDICATOR WARNING LIGHT/ALARM IS ACTIVATED WHEN PLAT-
FORM IS RAISED LOWER PLATFORM AND DRIVE TO A FIRM LEVEL SURFACE.
4. 5. 6. Lift/Drive Select - This toggle switch is used to
select either drive or lift. After selecting a function, the
controller must be moved in the proper direction in
order to activate that function. This function must be
selected with the joystick in the neutral position. Oth-
erwise, the function select will not occur.
7. Horn - This push-button switch, when activated, per-
mits the operator to warn job-site personnel when the
machine is operating in the area.
Drive/Lift/Steer Joystick Control
Figure 3-9. Platform Control Components
1. Trigger Switch
2. Joystick Controller 3. Steer Switch
4. Emergency Stop Switch
4
2
3
1