JLG 740AJ Service Manual - Manual (Page 226)

SECTION 4 - BOOM & PLATFORM
4-10 – JLG Lift – 3121160
Replacing a Fixed End Bracket
1. Remove the bracket by removing the center pin,
washer, and snap ring. Install a new bracket then
reinstall the pin, washer, and new snap ring. After
installing the new bracket make sure that it rotates
correctly.
Replacing a Moving End Bracket
1. Remove bracket by removing all pins, washers, and
snap rings. Replace with a new bracket and reinstall
the pins, washers, and new snap rings. After install-
ing a new bracket make sure that it rotates correctly.