2N Analogue GSM gateway 2N EasyGate PRO - Manual, 1749 v1.03 - Manual (Page 25)

2N® EasyGate Pro parameters configuration 3.1
25
To cancel any programming step in the programming mode, press a . Having done
so, you can hear the refusal tone and can enter a new parameter number. Parameters
are saved when the saving tone is transmitted. Hang up to quit programming.
Example:
Dial
Confirma on Descrip on
Password entering, OK
Transmission volume parameter, OK
Set to medium level, saved
Non-existent parameter number, refusal
PC based Programming
For programming, connect EasyGate to a PC with a USB cable and make sure that the
PCManager UNI is installed. Programming is intuitive and easy. All steps are
accompanied with texts hints above all items you point at with the mouse.
EasyGate data uploading and storing, including firmware upgrade, are executed in a
special mode, in which EasyGate waits for about 3s after power up (all LEDs are on).
If instructed so by the PCManager UNI during this timeout, EasyGate remains in this
mode as long as it is necessary. If EasyGate is not reset after the PCManager UNI is
terminated, switch the system off and on again.
Language
selection
Data handling
Programming
tables
Monitoring
Figure 3.1
EasyGate
PC Manager UNI
basic screen