2N Analogue GSM gateway 2N EasyGate PRO - Manual, 1749 v1.03 - Manual (Page 30)

Table of Parameters 3.2
30
signaling channel. This function can’t solve problems, when Easy Gate receives
DTMF, it influences sending direction only and it is active only when Easy Gate
originates the call.
Setting options: Analogue – DTMF transmission trough voice channel
without change (0)
Digital – DTMF is muted in voice channel and is
transmitted digitally (1)
Default setting: Analogue
Beep after dialing end Function No.: 103
Select a beep to signal the end of dialing (beginning of outgoing call
establishing).
Setting options: YES(1)/NO(0)
Default setting: YES
Signaling
Line reversal indication for call in progress Function No.:110
Select call in progress signaling by telephone line polarity reversal on FXS
interface. There is voltage of reversed polarity on the telephone line during the
whole call.
Setting options: YES(1)/NO(0)
Default setting: NO
Tariff pulse when call starts/ends Function No.: 111
Signaling of call start or end by tariff pulse.
Setting options: None (0)- EasyGate doesn't send tariff pulse as
signaling of callstart/end.
Call end (1) - EasyGate sends tariff pulse when call
ends.
Call start (2)- EasyGate sends tariff pulse when call
starts.
Call start and end (3) - EasyGate sends tariff pulse
when call starts and ends too.
Default setting: None
Tariff pulse frequency Function No.: 112
Tariff pulse frequency setting.
Setting options: 16 kHz (0) - EasyGate transmits 16 kHz tariff pulses
12 kHz (1)- EasyGate transmits 12 kHz tariff pulses
Default setting: 16 kHz