2N Analogue GSM gateway 2N EasyGate PRO - Manual, 1749 v1.03 - Manual (Page 28)

2N® EasyGate Pro parameters configuration 3.1
28
Monitoring
Monitoring is active when EasyGate is in operation and registered to the mobilní
network. If EasyGate is not registered to mobile network, the COM is locked and no
monitoring can be made.
This simple informative function helps you identify:
n The GSM (UMTS) module type and IMEI ID;
n The SIM card IMSI ID and selected SMS service centre necessary for SMS
sending;
n The mobile provider's name and signal strength received by EasyGate - this
information helps you find the optimum signal location (the information is
updated in 10s intervals);
n The EasyGate line status – standby, outgoing call, incoming call including
telephone number. The serial port is locked during dialing and incoming call
ringing, so the PCManager reports serial port blocking.
Firmware Upgrade
The firmware actualization of 2N ® Easy Gate is done in programming mode using
PCManager UNI. Description of upgrade follows.
Upgrading procedure:
1. Run the PCManager UNI, select the language for displaying texts on the right-
hand side.
2. In menu File use Upgrade or select proper icon from bar. When the gateway
is not in programming mode, you will be instructed to switch the gateway on
and on.
3. If there is more then one file in the PCManager directory, chose one of them.
The upgrade takes place automatically. Do not switch your PC or EasyGate
off during the process of upgrading!
Caution
n The PCManager checks the software version in EasyGate and the upgrade
file. If the version in the file is new, everything is all right. An identical or
earlier software version is stored in EasyGate too but the PCManager
requires confirmation to be on the safe side.
Caution
n The manufacturer responds to clients' requirements with periodical
firmware updating. The current EasyGate firmware, PCManager and User
Manual are available on www.2n.cz.