2N Analogue GSM gateway 2N EasyGate PRO - Manual, 1749 v1.03 - Manual (Page 41)

Table of Parameters 3.2
41
CLIR - incognito Function No.: 701
Sets the calling line identification restriction (CLIR) for outgoing calls from Easy
Gate. Attention, before enabling it is necessary to activate this feature by mobile
operator, otherwise outgoing calls can be rejected by the mobile network.
Setting options: -According to provider (0) - depending on how the
function is selected in the moble network
-Activation (1) - ID is not sent.
-Suppression (2) - ID is always sent
Default setting: According to provider
Roaming enable Function No.: 702
You can make EasyGate work even if it is registered to a foreign mobilní network.
Setting options: -Disable (0) – the gateway logs out of a foreign
network and attempts to register again in within 5
minutes.
-Enable (1) - EasyGate works in any mobile network.
Default setting: Disable
Call Handover workaround Function No.: 703
This parameter offers a workaround to prevent problems during call handover into
the 1800 MHz (or 1900 MHz) band, caused by non-conforming configurations of
the network.
Setting options: -Disable (0) -Disable workaround.
-Enable (1) -Enable workaround.
-Select only when handover into a 1800/1900MHz band
fails.
Default setting: Disable
GPRS APN Function No.: -
GPRS APN (Access Point Name) for automatic setting.
Setting options: 0-40 characters
Default setting: blank
AMR Enable Function No.: 704
You can disable AMR (Adaptive Multi Rate) to improve voice quality in some GSM
networks
Setting options: -Enable (1)
-Disable (0)
Default setting: Enable