2N Analogue GSM gateway 2N EasyGate PRO - Manual, 1749 v1.03 - Manual (Page 49)

Voice function 4.1
49
Tariff pulses 16 or 12 kHz
EasyGate has tariff pulse transmitter. You can use tariff pulses for outgoing call
pricing. EasyGate offer pseudotariff only – tariff metering doesn’t correspond to real
price of call, tariff pulses are transmitted according to programmed parameters and
call duration. You must program specific parameters in call table to set tariff metering
for different prefixes of dialed numbers.
You can also program EasyGate to transmit tariff pulses as call connect/disconnect
signaling if your PBX cannot receive telephone line polarity change signaling.
Configuration of network services
EasyGate provides some of network services to improve possibility of usage. The
configuration is done by standard Star-Hash codes you can know from mobile phones.
To configure these services:
1. Hook off the telephone, you can hear the dial tone.
2. Enter the Star-Hash code described below.
3. Wait for information tone. You may wait about 3 seconds.
4. Hook on.
Information tones:
Confirmation - OK:
n Confirms that the service was configured correctly.
Confirmation - bad:
n Service was not correctly configured
n Service isn’t activated by your provider
Confirmation - service activated:
n Confirms that the service was configured correctly and the service is
activated.
Confirmation - service deactivated:
n Confirms that the service was configured correctly and the service is
deactivated.