2N Analogue GSM gateway 2N EasyGate PRO - Manual, 1749 v1.03 - Manual (Page 48)

Voice function 4.1
48
4.1 Voice function
Outgoing and incoming call establishing procedures for an analog telephone are
described for illustration. The procedures are the same for the EasyGate-PBX
connection, just remember to program call routing to PBX line with connected
EasyGate properly. Check EasyGate’s function by connecting a telephone before.
Suppose that a SIM card has been inserted, the PIN code entered or not required, the
antenna connected and EasyGate registered to the mobile network – the LED network
is permanently on - and you can hear the dial tone upon off-hook.
Outgoing Call
1. Hook off the telephone, you can hear the dial tone and the LED Line starts
flashing.
2. Dial the required subscriber number. Since EasyGate receives tone dialing by
default, select the DTMF mode. If your telephone transmits pulse dialing only,
program EasyGate to receive pulse dialing.
3. The delay between digits to be dialed may not exceed 5 s (programmable
parameter). After the latest digit and this delay the dialing end is signaled and
connection is established.
4. If the called subscriber is available, you can hear the ringing tone. If not, you
can hear the busy tone or any of the mobile network provider’s messages.
5. When the called subscriber answers the call, a call is established. The LED
Line is permanently on during the call.
6. Hang up to terminate the call. The LED Line goes off. If the called subscriber
is the first to hang up, you can hear the busy tone and hang up.
Incoming Call
1. Ringing signals an incoming call. The Line LED flashes during ringing. If
programmed so, EasyGate transmits the CLIP by FSK between the first and
second rings. Advanced telephone sets are able to display the CLI.
2. Hook off the phone to establish the call. The Line LED is permanently on
during the call.
3. Hang up to terminate the call. The Line LED goes off. If the called subscriber
is the first to hang up, you can hear the busy tone and hang up.
Automatic Call ("Baby Call")
If the BabyCall function is enabled, a pre-programmed period of time is counted down
after off-hook. If you do not start dialing within this timeout, EasyGate signals dialing
end and starts establishing a call to the pre-programmed number automatically – from
now on EasyGate behaves as if a standard outgoing call had been established. Any
dialing during the BabyCall timeout cancels this function and a standard outgoing call
can be made.