2N VoiceBlue Enterprise - User Manual - Manual (Page 31)

Administration 3-7
3.2.2.1 Menu Command Line
Menu Command line allows you to control and configure
VoiceBlue lines, routes and LCR. Because of its complexity, this
menu is implemented as a command shell. To return back from
this menu type exit (this is the difference to the other menus which
you can exit by pressing the Esc key - pressing the Esc key in this
menu has no effect). To obtain a list of all the implemented
commands type help. Short help for each command can be
obtained by typing <command> help.
There are seven commands implemented - calls, devices, disa,
h323, lcr, route and sip. They will be discussed in the following (in
an alphabetical order).
3.2.2.1.1 Command ‘calls’
Command calls prints a list of all active VoiceBlue calls. This
command performs the same action as submenu Calls in States
menu (see Section 3.2). Printed list has the same form as a list
obtained in the Web Browser menu Devices.
3.2.2.1.2 Command ‘devices’
Command devices prints a list of all present VoiceBlue devices.
This command performs the same action as submenu Devices in
States menu (see Section 3.2). Printed list has the same form as a
list obtained in the Web Browser menu Devices.
3.2.2.1.3 Command ‘disa’
Command disa allows you to set, modify and delete DISA lines.
There are following parameters to this command:
help - prints short help
list - prints a list of all DISA lines
ls - same as a previous command
add - adds DISA line to the list, there are other parameters needed,
none of them required
type=basic|uploaded - specifies Type of DISA