2N VoiceBlue Enterprise - User Manual - Manual (Page 33)

Administration 3-9
3.2.2.1.4 Command ‘h323’
Command h323 allows you to set, modify and delete H.323 lines.
There are following parameters to this command:
help - prints short help
list - prints a list of all H.323 lines
ls - same as a previous command
add - adds H.323 line to the list, there are other parameters needed,
only numbers parameter is required (parameters can be written in
an arbitrary order).
numbers=<numbers> - specifies Numbers, required
c_meth=GK|GW|D - specifies Call method, GK for gatekeeper,
GW for gateway, D for direct
d_meth=AUTO|ADDR - specifies Gatekeeper discovery method,
AUTO for Discover automatically,
ADDR for Use gatekeeper address
gk_addr=<gatekeeper address> - specifies Gatekeeper address
gk_name=<gatekeeper name> - specifies Gatekeeper name
gw_addr=<gateway address> - specifies Gateway address
prefixes=<prefixes> - specifies Prefixes
endpt=GW|T - specifies Endpoint type, GW for gateway, T for
terminal
disp_name=<display name> - specifies Display name
listen_port=<port num> - specifies Listen port number
F_S_EN|F_S_DIS - disables or enables Fast start
E_S_EN|E_S_DIS - disables or enables Early media start
T_EN|T_DIS - disables or enables H.245 tunneling
dtmf=SIG|AN - specifies DTMF type, SIG for Signal, AN for
Alphanum
t_meth=CF|CT - specifies Transfer method, CF for Call
forwarding, CT for H.450.2 call transfer