2N VoiceBlue Enterprise - User Manual - Manual (Page 36)

3-12 2N
®
VoiceBlue Enterprise
list [<idx>] - prints a list of all LCRs or lists only LCR with <idx>
specified
ls [<idx>] - same as a previous command
add - adds LCR to the list, there are other parameters needed, some
of them required (parameters can be written in an arbitrary order).
destination=<destination name> - specifies Destination name,
required
prefix=prefix1,prefix2,...,prefix8 - specifies Prefixes, can be
regular expressions,
separated by comma, maximal eight prefixes allowed, not required
enabled|disabled - enables or disables added LCR, required
route=<valid route name> - specifies route for LCR, route must be
valid, required
priority=pr_type_1,pr_type_2,pr_type_3,pr_type_4 - specifies
Priority types,
valid values are first_free, cycles and free_minutes, value default
will be used for not specified priority type number (default value is
not listed), at most four Priority types are allowed, separated by
comma, not required
desc=<description> - specifies Description, not required
replace idx=<idx> - replaces LCR with an <idx> specified. If LCR
list is empty, this
command is not allowed, same parameters as for previous
command are possible, if some parameter is omitted when
replacing, original value will be used
del <idx> - deletes LCR with an <idx> specified
shift from=<from idx> to=<to idx> - shifts LCR from the position
<from idx> to the
position <to idx>, this usually takes some time
enable <idx> - enables LCR with an <idx> specified
disable <idx> - disables LCR with an <idx> specified
Example: There are two LCRs in a list. User decides to insert new
disabled LCR between them with Destination name value ”lcr3”,