2N BRI Lite/Enterprise v1.8 - Manual (Page 37)

37
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Make sure that the apriopriate provider's SIM card is inserted in the GSM gateway.
Assign the incoming and outgoing groups in the Gateway configuration / GSM
menu. groups assignment
For a call setup, the LCR table is searched sequentially from top to bottom. Each LCR
table row is assigned a
in which the prefix match is searched for. If a match Prefixlist
is found, the call will be routed according to the routing group parameters ( in Groups
the LCR table) as set in the table. Gateway configuration GSM outgoing groups /
The call will be connected via the GSM module as assigned to the GSM outgoing
in the table. groups GSM groups assignment
If the selected GSM/UMTS module is busy, the call is routed according to the next
routing rule included in the
and defined by the table. Groups GSM outgoing groups
Again, the is assigned to a GSM module in the GSM outgoing group GSM groups
table. assignment
The LCR row is checked in this way until a free GSM/UMTS module is found. If no
available GSM/UMTS module (
) is found, the call is rejected. GSM outgoing groups
Outgoing GSM Call Routing from Internal ISDN
If the GSM/UMTS gateway is connected to a subscriber line of your PBX, you are
advised to enable the DISA function to GSM to make your GSM gateway answer every
call routed to it by the PBX and wait for further dialling to GSM networks.
The GSM/UMTS gateway routes outgoing calls to GSM as follows:
The calling subscriber dials a user number.
If the user dialling is evaluated as
, the gateway barred Access to GSM gateway
number table is searched through and, if a match is found, the call setup request
is rejected.
With an outgoing call, the gateway waits for further digits to be dialled. This
timeout results in a certain delay between the subscriber's dialling and the
subsequent dialling by the GSM gateway. Therefore, select the Count of dialled
for the called destinations while configuring your gateway. Then, the digits
gateway initiates the outgoing call processing algorithm on receiving the last
digit.
The dialling prefix is first checked against the prefixes included in the first row of
the LCR table. If no match is found, the following row is used for check and so
on.
In case the prefix and call time comply with the routing rules, the call is routed
according to the first LCR rule to the module corresponding to the particular
included in the list. Outgoing GSM group Groups
Poznámka
Count of digits defines the minimum count of digits to be dialled. Hence,
a call is successful if the count of the called number digits is equal to or
higher than the value set in the
. Count of digits
The does not include the digits removed from/added to Count of digits
the number in the Table of replaced prefixes.
The
set in the Table of accepted prefixes has a higher Count of digits
priority than the . Default count of digits
The must always contain one record at least Table of replaced prefixes
or the record if no prefix modification is made. "/"