Monitoring, Common settings, Snmp – 2N BRI Lite/Enterprise v1.8 User Manual
Page 88
88
Monitoring
This section helps you configure sending of SNMP traps. Download the list of available
traps, i.e. the MIB table, from the gateway web interface. The main purpose of SNMP
monitoring is to observe your GSM gateway states continuously and send state
information to the defined IP addresses whenever an error occurs.
Refer to the
for the list of all SNMP traps sent by
.
List of SNMP traps
2N BRI
®
Common Settings
General
– define the maximum/minimum level of the signal received by the
Signal level
GSM/UMTS module. The SNMP trap is sent automatically whenever the defined
values are exceeded.
– define the maximum filling capacity of the SMS
SMS bufer upper limit
storage. The SNMP trap is sent automatically whenever the defined value is
exceeded.
SNMP
General
– enable/disable the SNMP service.
Enabled
– SNMP community is a group that owns the device and control
Community
stations on which SNMP is running. Default value = public.
Caution
This service is subject to licence! Refer to Management / Licence key
for the current GSM gateway licence state details.
Tip
You can also apply ISDN monitoring to monitor the ISDN PRI line state.
Refer to
for
Gateway Configuration / ISDN Parameters – Monitoring
details.