User group – 2N BRI Lite/Enterprise v1.8 User Manual
Page 77
77
outgoing SMS delivery confirmation
.
Send message as Flash SMS – activate the Flash SMS function for
outgoing SMS messages.
User Group
This section helps you edit the User group and set the routing rules for the group's
incoming and outgoing SMS.
General settings
Set the basic parameters for SMS sending via SMTP/POP3 or SMPP.
Optional informations
Description – set the User group details.
Identical SMS limit – set the check of identical SMS messages, i.e. sequentially
sent messages with identical SMS PDUs. When the set limit is exceeded, the
excessive SMS messages are discarded without being sent.
Note
You can set the
parameter only if the
Delivery status required
SMTP/POP3 protocol is used.
With SMPP, the delivery information is active automatically in case the
service is required by the SMPP counterparty or via an incoming SMS
message from the GSM/UMTS network.
The user count is licence–limited. The highest possible count of licensed
users is 200. Refer to
for the current GSM
Management
Licence key
/
gateway licence details.