2N BRI Lite/Enterprise v1.8 - Manual (Page 72)

72
2N TELEKOMUNIKACE a.s., www.2n.cz
®
Table of replaced prefixes
Use this table to replace the prefix of the received number ('00' with '+', e.g.). You can
only add or remove the prefix. This change is made before the prefix is searched for in
the prefix table. Be sure to keep the „/" record in the table for a proper function.
Table of accepted prefixes
List of prefixes of called destinations to which the selected prefix list applies.
LCR Table
The Least Cost Routing (LCR) table helps you route calls according to the called party
number, time and days in a week.
Prefix list – prefixes to be used for a selected LCR row.
Time limitation – time validity limitation for a selected LCR row.
Weekend usage – enable/disable a row on weekends.
Maximum length of call – set the maximum duration (minutes) for an outgoing
call to the GSM/UMTS network.
Groups – outgoing GSM groups used for the selected LCR row.
Fallback port (9): set the fallback port. If the fallback port service is
unavailable, the next LCR table row is applied. Select the appropriate
routing rule to set the fallback port in the Gateway configuration
Port /
. modes
Tariffs – select the tariff group (free minute counter) to be used for the outgoing
call. Refer to the
subsection for details. GSM outgoing groups
Ignore tone detection in last group – having detected a user defined tone (refer
to
), the GSM gateway automatically terminates the call and GSM basic settings
Note
The number to be dialled to the GSM/UMTS network must meet the
condition. Count of digits
For
calls, the count of digits to be dialled must be equal to or higher VoIP
than the value set in the . Count of digits
For GSM/UMTS calls by overlap dialling via the interface, the BRI NT/TE
defines the maximum count of the digits to be dialled. Count of digits
For GSM/UMTS calls by block dialling via the
interface, the BRI NT/TE
is ignored. Count of digits
Note
The maximum count of records in the is 14 Table of replaced prefixes
for each prefixlist.
The maximum table record size is 9 characters for the prefix and 9
characters for the replaced number.
Note
The maximum count of records in the is 138 Table of accepted prefixes
for each prefixlist.
The maximum table record size is 9 characters.