2N BRI Lite/Enterprise v1.8 - Manual (Page 70)

70
2N TELEKOMUNIKACE a.s., www.2n.cz
®
General settings
Mode – set how the gateway shall process incoming calls from the GSM network.
Reject incoming calls – all incoming calls from the GSM network are
rejected automatically.
Ignore incoming calls – all incoming calls from the GSM network are
ignored. The calling party hears the check ring tone.
Accept incoming calls + voice message – incoming GSM calls are accepted
by the gateway and, if programmed so, DTMF with a voice message is
activated for them.
Accept incoming calls + dialtone – incoming GSM calls are accepted by the
gateway and, if programmed so, DTMF with a simulated second dialtone is
activated for them.
CallBack after ring / Reject – CallBack will be made if the CLIP is included
in the CallBack table. The other incoming calls will be rejected.
CallBack after ring / Ignore – CallBack will be made if the CLIP is included
in the CallBack table. The other incoming calls will be ignored.
Report to PC + voice message – the GSM gateway sends information on
the incoming call to a PC equipped with call routing application. If
programmed so, DTMF with a voice message is activated for the incoming
call.
Report to PC + dialtone – the GSM gateway sends information on the
incoming call to a PC equipped with call routing application. If programmed
so, DTMF with a simulated second dialtone is activated for the incoming
call.
Minimum digits in DTMF – set the minimum count of digits to be requested by the
gateway for DTMF.
Maximum digits in DTMF – set the maximum count of digits to be accepted by
the gateway for DTMF.
Timeout for entering DTMF digits [s] – set the timeout for which the GSM
gateway shall wait for the first/next DTMF digit. If you select '0', the incoming
call will be automatically connected to the numbers included in the List of called
. numbers
Day of deleting GSM group statistics – set a day in a month on which the
incoming call statistics shall be deleted.
Prefix before DISA – set a numerical prefix to precede DTMF.
CLIP – use this parameter to modify the incoming CLIP from GSM/UMTS. For
international codes, '+' will be removed automatically. Use '–' to remove a digit.
Examples (CLIP in GSM: +420600123456):
Parameter CLIP to VoIP/PRI 1 Note
Null 420261301500 No CLIP change
+ +420261301500 Add + before CLIP
00 00420261301500 Add 00 before CLIP
– 0261301500 First two digits removed from CLIP
–––99 99261301500 First three digits removed from CLIP, prefix 99 added
Looping of voice message – set the voice message playing time.