Barco SLM R12+ - Manual (Page 102)

8. Installation Mode
Defining the communication protocol.
1. Push the cursor key ↑ or ↓ to highlight 800 Peripheral.
INSTALLATION
INPUT SLOTS
800 PERIPHERAL
SOURCE SWITCHING
NO SIGNAL
CONTRAST ENHANCEMENT
CONVERGENCE
CONFIGURATION
LENS
QUICK ACCESS KEYS
OSD
INTERNAL PATTERNS
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-7
2. Press ENTER to select.
3. Push the cursor key ↑ or ↓ to highlight Infrared.
800 PERIPHERAL
OUTPUT MODULE [STANDARD]
CLO USING COMM800 [YES]
INFRARED [PPM]
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-8
4. Press ENTER to select.
5. Press ENTER to toggle between [PPM] or [RC5].
8.3.3 CLO using Comm 800
What can be done?
CLO can be activated in a linked system setup using the COM800 Protocol + Ports.
By using the COM800 Protocol + Ports, the RS232 Ports can be used for a RS232 linked setup, CLO is received
through the COM800 Ports, general RS232 commands are received through the RS232 Ports.
How to change the COM800 Protocol Activation?
1. Push the cursor key ↑ or ↓ to highlight CLO using COM800: [NO].
800 PERIPHERAL
OUTPUT MODULE [STANDARD]
CLO USING COMM800 [YES]
INFRARED [PPM]
Select with ↑ or ↓
then <ENTER>
<EXIT> to return
Menu 8-9
2. Press ENTER to toggle between [NO] or [YES].
[No] CLO will not use Comm800 protocol
[Yes] CLO will use Comm800 protocol
98 R5976654 SLM R12+ 27/01/2005