5 using the rcu, Using the rcu, Getting started – Barco SLM R12+ User Manual
Page 57: Pointing to the reflective screen, Hardwired remote input
5. Getting Started
5.5 Using the RCU
Pointing to the reflective screen
1. Point the front of the RCU to the reflective screen surface.
Ceiling
Screen
IR sensor
RCU
Image 5-5
Hardwired Remote Input
1. Plug one end of the remote cable in the connector on the bottom of the RCU.
2. Plug the other end in the connector in the front panel of the projector labelled RC.
OUT
IN
On
R
9840450
HD SDI DIGITAL MODULE
OUT
IN
On
9840110
SDI DIGITAL INPUT
COMM PORT
10/(100) BASE-T
RS232/422 OUT
RS232/422 IN
IR-Receiver
Diagnostic Code
Green Operation
Red Stand-by
IR
Sync OK
Hardwired
remote
CTRL 1
Hardwired
remote
CTRL 2
Two way
hardwired
remote
CTRL 3
On
On
On
On
RCU
DVI INPUT
DVI INPUT
DVI OUTPUT
High Bandwidth 5 CABLE INPUT
High Bandwidth 5 CABLE INPUT
R
G
B
H/C
V
R
G
B
H/C
V
Image 5-6
R5976654 SLM R12+ 27/01/2005
53