Barco SLM R12+ - Manual (Page 146)

B. Built-In Dust Filters
B.2 Built-In Dust Filters recent series projectors
C AUTION : Always turn off the projector before proceeding to dust filter cleaning or replacement.
To avoid contaminating the projector with its removed dust filters, clean the dust filters far away from the
projector or by preference clean the filters in another room.
B.2.1 Location of the Dust Filters
Where mounted?
To protect the projector against internal contamination due to forced air cooling, dust filters are mounted at the air inlet of the projector.
Therefore 2 casings are provided onto the front and the rear of the projector containing an air filter.
A
B
Image B-10
Location of the dust filters
A Dust filter at the front side of the projector
B Dust filter at the rear side of the projector
Order number Air filters
Order No Description
R8454096k Air filter – 6 pack
R84540924K Air filter – 24 pack
B.2.2 Cleaning/Replacement of the Dust Filters
B.2.2.1 Dust filter on the front side of the projector
Necessary tools
Philips screwdriver P1 or Flat blade screwdriver of 5 mm.
How to Remove!
1. For a table mounted projector, put one hand (A) under the filter casing (Dust filter will drops when the captive screws are loos-
ened).
142 R5976654 SLM R12+ 27/01/2005