Machine operation, Initial preparation, Tractor requirements – Kinze 3000 Rigid Frame Planter Rev. 6/14 User Manual

Page 13: Initial preparation -1, Tractor requirements -1

Advertising
background image

TM

Model 3000

M0188-01

Rev. 2/14

2-1

Machine Operation

INITIAL PREPARATION

1. Torque transport wheel 9∕16"- 18 lug bolts to 90 ft-lb (122 N-m).

2. Inflate transport/ground drive tires to 40 psi (275.7 kPa).

3. Inflate contact drive tires to 50 psi (344.7 kPa).

Following information is general in nature to aid in preparation of tractor and planter for use, and to provide general

operating procedures. Operator experience, familiarity with the machine, and the following information should combine

for efficient planter operation and good working habits.

wARNING

Improperly operating or working on this equipment could result in
death or serious injury. Read and follow all instructions in Operator
Manual before operating or working on this equipment.

wARNING

Loose transport wheel lug bolts can result in wheel separation
from planter and cause death, serious injury, and damage to
property and equipment. Torque transport wheel 9∕16"- 18 lug bolts
to 90 ft-lb (122 N-m) before operating planter for the first time and
periodically after.

wARNING

Explosive separation of rim and tire parts can cause death or serious
injury. Overinflation, rim and tire servicing, improper use of rims and tires,
worn, or improperly maintained tires could result in a tire explosion.

Contact drive

Transport/ground drive

TRACTOR REqUIREMENTS

NOTICE

All Hydraulic Requirements: Minimum Pressure 2350 PSI (16202.6
kPa); Maximum Pressure 3000 PSI (20684.2 kPa). Check tractor
hydraulics to ensure that maximum pressure cannot be exceeded.

Consult your dealer for information on horsepower requirements and tractor compatibility. Requirements vary with
planter options, tillage, and terrain.

A 12 volt DC electrical system is required for all 3000 series planters.

One dual remote hydraulic outlet (SCV) is required for machines equipped with a standard single valve hydraulic system.
Two dual remote hydraulic outlets (SCV) are required for machines equipped with the optional dual valve hydraulic system.

Advertising