Kinze 3000 Rigid Frame Planter Rev. 6/14 - Manual (Page 134)

M0188-01 Model 3000
7-4 Rev. 6/11
TM
Lubrication and Maintenance
Components may require occasional lubrication
to operate correctly. Disassembly is required to
lubricate.
1. Remove ¼ "-20 x ½" cap screw that secures idler
assembly to wrap spring wrench tightener shaft.
2. Remove wrap spring wrench from planter.
3. Tip wrap spring wrench on its side and lubricate
with a high quality spray lubricant. Lubricant
must be absorbed into wrap spring area.
4. Reinstall wrap spring wrench on planter.
INTERPLANT PUSH ROw UNIT LOCKUPS
2 Per Row
wRAP SPRING wRENCH ASSEMBLY
wrap Spring wrench Lubrication
wHEEL BEARINGS
Inspect all drive, transport, and marker hub wheel
bearings annually and repack/replace as needed.
1. Raise wheel off ground.
2. Check bearing endplay by moving wheel side to
side.
3. Rotate wheel to check bearing roughness. If
bearings sound rough, hub should be removed
and bearings inspected and replaced as needed.
To repack wheel hubs, follow procedure outlined for
wheel bearing replacement except bearings and
bearing cups are reused.
LIqUID FERTILIzER PISTON PUMP
CRANKCASE OIL LEVEL
Check crankcase oil daily and maintain at plug level.
Fill as needed with EP 90 weight gear oil. Total oil
capacity is approximately ¾ pint.
Refer to operator and instruction manual supplied
with pump and flow divider for additional information.
Plug
Plug
Piston pump oil fill plug location