Kinze 3000 Rigid Frame Planter Rev. 6/14 - Manual (Page 84)

M0188-01 Model 3000
6-14 Rev. 6/11
TM
KPM II Monitor Operation
NOTE: The monitor limits entry of row spacing
from 10.0 inches (25.4 cm) to 99.9 inches (253.7
cm). If the monitor is configured to a rear/front
configuration, the limits change to a minimum
of 5.0 inches (12.7 cm) and a maximum of 49.9
inches (126.8 cm).
STEP 5 To exit without saving, press and release
the OK key. The monitor restores the lower
LCD to show the setting of the item and the
arrow icon will flash, allowing the user to
select another item to program.
To exit and save, press and hold the OK key.
The monitor will emit several short beeps
and SAVE? icon is turned on. After a short
time a long beep is heard, and the lower
LCD will display the word “DONE”. Release
the OK key. If the OK key is released
BEFORE the word “DONE” is displayed,
the changes WILL NOT BE SAVED. The
word “DONE” MUST be displayed in order
for the save to have occurred.
To exit setup mode, press the SETUP key.
NOTE: The programming mode may be exited at
any time, by pressing the SETUP key. Pressing
this key will return the monitor to its normal
operation. All items changed and saved will come
into effect immediately. Any items changed, but
not saved revert to original programmed value.