Kinze 3000 Rigid Frame Planter Rev. 6/14 - Manual (Page 20)

M0188-01 Model 3000
TM
Machine Operation
2-8 Rev. 1/14
There are two down pressure springs on each contact drive wheel. Spring tension is factory preset and normally
requires no adjustment.
Basic setting for spring tension is approximately 200 lb (90.72 kg) of down force at tire contact point.
NOTE: Measurement must be taken in planting position with proper tire pressure.
TRANSPORTING PLANTER
wARNING
All safety/warning lights, reflective decals, and SMV sign must be
in place and visible before transporting machine on public roads or
death, serious injury, and damage to property and equipment may
result. Check federal, state/provincial, and local regulations before
transporting equipment on public roads.
DANGER!
Contacting or coming close to power lines or other high energy
sources will cause death or serious injury. Keep away from power
lines or high energy sources at all times.
• Tow only with farm tractor rated and configured for equipment.
• Know your route and be aware of any obstructions.
• Follow all road and bridge load limit restrictions.
• Never exceed maximum transport towing speed of 20 mph (32 kph).
1. Raise planter to full turn around height.
2. Install safety lockups. See “Safety Lockups” in Machine Operation.
3. Turn on hazard lights.
CONTACT DRIVE SPRING ADJUSTMENT
Down pressure spring location
8" (20.3 cm)
Spring length measurement (Factory setting)