Kinze 3000 Rigid Frame Planter Rev. 6/14 - Manual (Page 83)

TM
Model 3000 M0188-01
Rev. 6/11 6-13
KPM II Monitor Operation
PROGRAMMING - UNITS (METRIC OR ENGLISH)
STEP 1 Press and hold SETUP key to enter
programming mode. The monitor emits
several short beeps, followed by a long
beep. On the lower LCD, the SETUP icon
turns on and the arrow head icon will flash,
indicating that the user can select an item
to program.
NOTE: The monitor must be in a programmable
function (row spacing, units, speed, volume or
area) to enter setup. The monitor will not enter
setup in seed population or seed spacing.
STEP 2 Press UP or DOWN arrow keys to move
the flashing arrow to UNITS. As the arrow
icon moves, the lower LCD will display the
current setting of the item selected.
STEP 3 Press the OK key and the flashing arrow
becomes solid and audible alarm sounds.
NOTE: Lower LCD alternately displays Metric or
English icons, indicating Metric or English mode.
•Use UP or DOWN arrow keys to change
the setting.
STEP 4 Press and release the OK key to exit
without saving. The monitor restores lower
LCD to show item setting, and the arrow
icon flashes, allowing user to select another
item to program.
Press and hold OK key to exit and save.
The monitor emits several short beeps and
SAVE? icon is turned on. After a short time
a long beep is heard, and the lower LCD
displays “DONE”. Release the OK key. If
the OK key is released BEFORE “DONE”
displays, changes WILL NOT BE SAVED.
“DONE” MUST be displayed for the save to
have occurred.
NOTE: Programming mode may be exited at any
time, by pressing the SETUP key. Pressing this
key returns the monitor to its normal operation.
All items changed and saved come into effect
immediately. Any items changed, but not saved
revert to original programmed value.
PROGRAMMING - ROw SPACING
STEP 1 Application mode (rear/front, left/right
or four sections) must be active before
entering programming mode. If monitor is
programmed in a rear/front configuration,
both sections are active (alternating every
5 seconds if the SMM console is not used).
You can then set row spacing to Interplant
System row spacing.
EXAMPLE: On a 12 Row 30" with
Interplant
® Package set the row spacing to
15.0 with front active.
When monitor is in normal field operation
mode, disabling the front section
automatically changes row spacing to 30".
STEP 2 To enter the programming mode, press and
hold the SETUP key. The monitor will emit
several short beeps, followed by a long
beep. On the lower LCD, the SETUP icon
turns on and the arrow head icon will flash,
indicating that the user can select an item
to program.
NOTE: Monitor must be in a programmable
function (row spacing, units, speed, volume or
area) to enter setup. The monitor will not enter
setup in seed population or seed spacing.
STEP 3 Press UP or DOWN arrow keys to move
flashing arrow to ROW SPACING. As arrow
icon moves, lower LCD displays current
setting of selected item.
STEP 4 Press OK key and flashing arrow becomes
solid and the audible alarm sounds.
NOTE: Lower LCD displays current row spacing
(in inches or centimeters) and ROw SPACING
icon is turned on.
•Least significant digit of displayed value
blinks.
•This value can be changed by pressing
UP or DOWN arrow keys.
•Once digit is correct, press MODE
SELECT key and blinking digit moves to
next significant digit, where process can be
repeated.