Leica Biosystems IPS - Manual (Page 52)

50 Instructions for Use V 1.9 RevD - 05/2013
5. Operation
"ADVANCED OPTIONS" menu
Clicking onto the individual menu items opens up
a pull-down menu to their right, where you can
select the desired parameters.
Any menu items not described here are of no im-
portance for the printer. Therefore, the standard
settings of all menu items not described here
should remain unchanged.
• In the PAPER SIZE menu you select the size of
the imprintable zone of the
slide. Slide must be selected
in this menu, otherwise
printing will not be possible.
• Selectable print head RESOLUTION settings
are 360 and 180 dpi. With
slide surfaces not appropri-
ate for 360 dpi resolution,
printing results will be poor.
For such cassettes, 180 dpi should be selected.
• The PAPER/OUTPUT menu item is important
above all for the multi-cas-
sette unload station.
• SAME TRAY:
slides keep being deposited into a tray until
the tray is full.
• JOB IN NEW TRAY:
each print job starts with a new tray.
• NEW TRAY:
Only for special applications—do not select
this option under standard Windows programs.
Fig. 48
• PRINT QUALITY menu item
In this menu, you can select
whether an imprint is to be
applied onto a specimen
slide once (NORMAL) or
twice (OVERSTRIKE).
UPSIDE DOWN imprints are rotated 180°. Here
again, OVERSTRIKE can be selected.
Due to the higher ink consumption and
the substantially poorer printed image,
the OVERSTRIKE setting may not be
used.
When using the manual unloading
system, the values configured in the
PAPER/OUTPUT menu item are not
considered by the device.