Leica Biosystems IPS - Manual (Page 60)

58 Instructions for Use V 1.9 RevD - 05/2013
6. Cleaning and Maintenance
Transporting the printer
If the printer is to be shipped, the storage instructions described above
are to be carried out completely. Then, additionally make the following
preparations:
• Open the hood (4, Fig. 31 ) of the printer and loosen the screw of the flash
cover.
• Afterward, take out the flash bulb (refer to Chapter 4.7 )
• Close the flash cover and the hood.
• Use original packaging and securely screw the printer to the baseplate
(see unpacking instructions).
• Reinsert the transport anchor (27) (see Fig. 12 ) and secure the hood with
adhesive tape.
• Make sure that the instrument is only transported upright.
• Likewise, clean the removed removable disk
(70) with the sealing lip with (clean) alcohol
and a cleaning swab (89) ( Fig. 62 ).
• The sealing lip (71) must be completely free
of ink residue. Check the sealing lip for dam-
age. Do not reuse a replacement plate with a
damaged sealing lip .
• Clean the instrument completely, as described
in Chap. 6.1 .
Instructions for storage (continued)
Fig. 62
70
71
89