Lenze E931Ex - Manual (Page 11)

Safety instructions
General safety and application notes for Lenze controllers
2
l
11 GHB 13.0001−EN EN 3.0
2 Safety instructions
2.1 General safety and application notes for Lenze controllers
(in accordance with Low−Voltage Directive 2006/95/EC)
For your pesonal safety
During operation, Lenze controllers (frequency inverters, servo inverters, DC speed
controllers) and their corresponding components can be live, moving and rotating
according to their degree of protection. Surfaces can be hot.
Non-authorized removal of the required cover, inappropriate use, incorrect installation or
operation creates the risk of severe injury to persons or damage to material assets.
Additional information can be obtained from the documentation.
High amounts of energy are released in the controller. Thus, it is required to always wear
a personal protective equipment (body protection, headgear, eye protection, ear
protection, hand guard).
All operations concerning transport, installation, and commissioning as well as servicing
must be carried out by qualified, skilled personnel only (IEC 364 and CENELEC HD 384 or
DIN VDE 0100 and IEC−Report 664 or DIN VDE 0110. National regulations for the
prevention of accidents must be observed.).
According to this basic safety information, skilled personnel are persons who are familiar
with the installation, mounting, commissioning, and operation of the product and who
have the necessary qualifications for their occupation.
Application as directed
Drive controllers are components designed for the installation in electrical systems or
machinery. They must not be used as household appliances. They are intended exclusively
professional and commercial purposes according to EN 61000−3−2.
When installing the controllers into machines, commissioning (i.e. starting of operation as
directed) is prohibited until it is certain that the machine complies with the regulations of
EC Directive 98/37/EC (Machinery Directive). EN 60204 must be observed.
Commissioning (i.e. starting of operation as directed) is only allowed when there is
compliance with EMC Directive (89/336/EEC).
The controllers meet the requirements of the Low-Voltage Directive 2006/95/EC.
The technical data and information on the connection conditions can be obtained from the
nameplate and the documentation. They must be followed in any case.
Warning: Drive controllers are products with restricted availability according to
EN 61800−3. These products can cause radio interferences in residential areas. In this case,
special measures are required.
Transport, storage
Please observe the notes on transport, storage and appropriate handling.
Observe the climatic conditions according to the technical data.