3 ethernet interface, Ethernet interface, Device description – Lenze ETCxxxxx User Manual
Page 24
Advertising
Device description
Control in top hat rail design (ETCHx)
Ethernet interface
3.2
3.2.3
l
24
EDSTCXX EN 2.0
3.2.3
Ethernet interface
The interface is used to connect a PC terminal or to integrate the control
within a network. It is designed as a RJ45 plug−in connector. The cabling type
is 10 BASE−T.
Ethernet
Tx
Rx
Link
ETC036
Pin
Signal
Pin
Signal
1
TxD+
6
RxD−
2
TxD−
7
nc
3
RxD+
8
nc
4
nc
5
nc
The LEDs on the front plate indicate the following states:
Tx, Rx
Data transfer via the interface
LNK
Result of the internal 10 BASE−T Link Integrity Test. It illuminates as soon as
an Ethernet connection has been established.
)
Note!
If a point−to−point connection between control and PC terminal
is being set up, a "cross−over" cable must be used.
Connector allocation (8−pole
RJ45 connector)
Advertising