Lenze ETCxxxxx - Manual (Page 5)

Preface and general information
About this Manual
1
1.1
l
5 EDSTCXX EN 2.0
1 Preface and general information
The ETC Motion Control as the leading element of automation is together
with the Lenze drive controllers and motors an optimal system solution for
the control of movements.
In the ETC system both compact controls for installation on top hat rails and
PC insert cards are available. In both hardware designs either a NC or a MC
core can be supplied. The programming of the NC is carried out in accordance
with DIN 66025 (G code), that of MC in accordance with PLCOpen. Both
controls also include a PLC with is programmed in accordancd with 61131−3.
The control system is complemented by the corresponding I/O
subassemblies.
The communication with the drives via CAN or to the PC level via Ethernet
TCP/IP is also integrated into the ETC.
1.1 About this Manual
This manual is intended for all those who plan, install, program or
commission the ETC Motion Control System under the "NC" operating
system.
The ETC device manual contains information on the following topics:
ƒ Technical data
ƒ Structure and function of the system components including interface
description
ƒ Mounting, connecting and maintaining system components
This manual is complemented by the software manuals "MC operating
system" and "NC operating system", which provide important information
for the programmer and commissioner.
I
Tip!
Current documentation and software updates concerning Lenze
products can be found on the Internet in the "Services &
Downloads" area under
http://www.Lenze.com
Target group
Contents
Further information