Lenze ETCxxxxx - Manual (Page 52)

Mechanical installation
Control in PCI design (ETCPx)
Installing the PCI card in the PC
4
4.2
4.2.1
l
52 EDSTCXX EN 2.0
4.2 Control in PCI design (ETCPx)
4.2.1 Installing the PCI card in the PC
(
Stop!
Only install the PCI control variant ETCPx after installing the
ETC−MMI and before starting the ETC−MMIs.
{
Danger!
Dangerous electrical voltage!
Dangerous electrical voltage may be present at the components
and connections of the PC.
Potential consequences:
ƒ Death or severe injury when making contact with components
or connections.
Protective measures:
ƒ Disconnect the PC and all connected devices from the mains
before opening the housing.
(
Stop!
Electrostatically sensitive components!
ƒ The PCI card ETCPX0XX contains sensitive electronic
components which may be damaged by electrostatic
discharge if the card is touched.
Protective measures:
ƒ Divert electrostatic charges using suitable measures (e.g. wrist
earthing strip, antistatic work surface).
1. Switch off the PC.
2. Remove the housing cover from the PC.
3. Remove the cover of an available PCI slot.
4. Check the configuration of the jumpers on the ETC insert card.
5. Gently press the PCI card ETCPX0XX evenly into its slot.
Ensure that the PCI card does not touch any adjacent components.
6. Attach the PCI card with the screw which was previously used to attach
the cover.
7. Close the PC housing cover.