SATEC EM720 Operation Manual - Manual (Page 62)

Chapter 5 Configuring the EM720
Configuring Communications
62 EM720 Power Quality and Revenue Meter
Setting Up the Ethernet
Using the Front Display
Select Net from the main menu. See Viewing and Changing
Setup Options in Chapter 3 for information on navigating in
menus.
See the table below for available network options.
Using PAS
Select Communications Setup from the Meter Setup menu,
and then click on the Network Setup tab.
The following table lists available network options.
Display Label Parameter Default
IP Address Device IP Address 192.168.0.203
Subnet Mask Network Subnet Mask 255.255.255.0
Def. Gateway Network Default Gateway 192.168.0.1
NOTE
When you change the device network settings through the
Ethernet port, the device port restarts so communication will
be temporarily lost. You may need to wait some additional
time until PAS restores a connection with your device.