Therma-Tru Doors Installation - Manual (Page 21)

Installation
SITE 1 2014 1.21
Multi-Point Lock
Quick Tip Sheet & Instructions
Exterior
Lever Handle
Exterior
Backplate
Gasket
Interior of
Door Stile
Gasket
Interior
Backplate
2” Phillips Head Brass Screws
(Two or Three Provided
Depending on the Backplate)
Nylon
Bushing
Interior
Lever Handle
Set Screw
(Two Provided)
Lock Cylinder
Thumbturn
2” Phillips Head
Cylinder Screw
(One Provided)
Mishandling
Device
Required Shaft
Position for Set
Screw
Construction
Handle
A Phillips screwdriver is required.
A Hex wrench for set screws is
provided in the hardware package
To prevent damage to the handle set
while in the construction phase, use
the enclosed construction handle to
operate the door. Lift to engage
multipoint to close door. Push down
to open the door.
Use water to clean. Do not use brass
cleaner as it will remove the
protective coating. Brass Strike
Plates are Solid Brass and can be
polished as needed.
Note: Handles and backplates vary
by style but application is the same.
1. Apply the backplate gasket to the inside of the
exterior backplate. Push gaskets firmly into place to
ensure a tight seal. Attach interior and exterior
backplates to the door and fasten loosely with the
screws provided. Note: The screw heads must be
on the interior side of the door.
2. Mount nylon bushings to door gear handle hole on
interior and exterior backplates.
3. Insert the two piece handle shaft into one handle. Be
sure to orient the shaft as shown below. Screw the
set screw until flush with handle using the allen
wrench provided. Insert the handle with the shaft
through the backplate and door gear handle hole
until extending out opposite side of door.
4. Install remaining handle onto shaft, pressing tightly to
the backplates. Tighten the handle set screw with
the allen wrench. Screw until flush with handle.
5. Attach thumbturn to cylinder.
6. Insert the keyed cylinder from the interior side of the
door until it is flush with the exterior backplate. Install
the cylinder screw in the screw hole below the
deadbolt in the edge of the door. If passive deadbolt
will not turn, it is installed incorrectly. See Installation
Instructions for active & passive 90-Degree Cylinder.
7. Tighten the backplate screws.
Swing Door Handle Set Installation Instructions