Rockwell Automation 20-COMM-B BACnet MS/TP Adapter - Manual (Page 3)

Summary of Changes
The information below summarizes the changes made to this manual
since its last release (May 2006):
The information below summarizes the changes made to this manual
since its last release (April 2006):
Description of Changes Page(s)
In the “Quick Start” section:
• In Step 4, removed connecting the adapter to the network.
• In Step 5, added two new sub-steps (B and C).
• Added a new Step 6 “Connect the adapter to the network.”
• Incremented old Steps 6 and 7 to Steps 7 to 8. 1-6
Reorganized Chapter 2:
• Moved the “Connecting the Adapter to the Drive” section after the
“Commissioning the Adapter” section.
• Moved the “Applying Power” section after the “Connecting the Adapter to
the Drive” section.
• In the “Applying Power” section, added three new subsections:
– “Start-Up Status Indications”
– “Verifying/Setting Key Adapter Parameters”
– “Configuring/Verifying Key Drive Parameters.”
• Moved the “Connecting the Drive/Adapter to the Network” section to the
end of the chapter.
Chapter 2
In Chapter 3, moved the “Setting the Device Instance Number” section after
the “Using the PowerFlex 7-Class HIM” section. Included additional
information to the “Setting the Device Instance Number” section. 3-3
Added new Appendix D “Routing Capability for Networked Drives.” D-1
Description of Changes Page(s)
In the Features section — first bullet, removed text “... and can be used with
the kit’s optional I/O board.” Also, added an Important statement regarding
this information. 1-2
In the Viewing the Adapter Configuration table, added a third bullet in the
Parameter 07 - [Baud Rate Act] row. 3-8
For Parameter 05 - [Flt Cfg Ref], corrected its detail information from being a
bit parameter to a numeric parameter. B-2