Rockwell Automation 20-COMM-B BACnet MS/TP Adapter - Manual (Page 36)

3-8 Configuring the Adapter
When you enter 1 = Reset Module, the adapter will be immediately
reset. When you enter 2 = Set Defaults, the adapter will set all adapter
parameters to their factory-default settings. After performing a Set
Defaults, enter 1 = Reset Module so that the new values take effect. The
value of this parameter will be restored to 0 = Ready after the adapter is
reset.
The following read-only parameters provide information about how the
adapter is configured. You can view these parameters at any time.
Viewing the Adapter Configuration
Number Name Description
07 Baud Rate Act The baud rate used by the adapter. This will be one of the
following values:
• The value of Parameter 06 - [Baud Rate Cfg].
• An old baud rate if Parameter 06 - [Baud Rate Cfg] has
been changed and the adapter has not been reset.
• The value “0” (Unknown) if Parameter 06 - [Baud Rate Cfg]
is set to “0” (Autobaud) and the adapter has not yet detected
the baud rate.
08 MAC Address The MAC address used by the adapter that was set by the
MAC Address Switches SW1-SW7 ( Figure 2.1 ).