Rockwell Automation LPM20 Liquid-Cooled AC Drive with High Performance Drive Control - Manual (Page 10)

P-4 Overview
General Precautions Class 1 LED Product
!
ATTENTION: Risk of permanent eye damage exists when using
optical transmission equipment. This product emits intense light
and invisible radiation. Do not look into module ports or fiber
optic cable connectors.
!
ATTENTION: This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control precautions are
required when installing, testing, servicing or repairing this
assembly. Component damage may result if ESD control
procedures are not followed. If you are not familiar with static
control procedures, refer to Allen-Bradley publication 8000-4.5.2,
“Guarding Against Electrostatic Damage” or any other applicable
ESD protection handbook.
!
ATTENTION: An incorrectly applied or installed drive can
result in component damage or a reduction in product life. Wiring
or application errors, such as, undersizing the motor, incorrect or
inadequate AC supply, or excessive ambient temperatures may
result in malfunction of the system.
!
ATTENTION: Only qualified personnel familiar with adjustable
frequency AC drives and associated machinery should plan or
implement the installation, start-up, and subsequent maintenance
of the system. Failure to comply may result in personal injury and/
or equipment damage.
!
ATTENTION: To avoid an electric shock hazard, verify that the
voltage on the bus capacitors has discharged before performing
any work on the drive. After removing power to the drive, wait 5
minutes for the bus capacitors to discharge. Measure the DC bus
voltage at the locations shown in
Figure 3.2 . The voltage must be
zero.
!
ATTENTION: Risk of injury or equipment damage exists. DPI
or SCANport
™ host products must not be directly connected
together via 1202 cables. Unpredictable behavior can result if two
or more devices are connected in this manner.
!
ATTENTION: Risk of injury or equipment damage exists.
Parameters 365 [Fdbk LsCnfg Pri] - 394 [VoltFdbkLossCnfg] let
you determine the action of the drive in response to operating
anomalies. Precautions should be taken to ensure that the settings
of these parameters do not create hazards of injury or equipment
damage.
!
ATTENTION: Risk of injury or equipment damage exists.
Parameters 383 [SL CommLoss Data] - 392 [NetLoss DPI Cnfg]
let you determine the action of the drive if communications are
disrupted. You can set these parameters so that the drive continues
to run. Precautions should be taken to ensure that the settings of
these parameters do not create hazards of injury or equipment
damage.