Rockwell Automation 842E CM Integrated Motion Encoder on EtherNet/IP - Manual (Page 12)

12 Rockwell Automation Publication 842E-UM002A-EN-P - November 2013
Chapter 1 Safety Precautions
Correct Use The 842E-CM Integrated Motion encoder is an instrument manufactured
in accordance with recognized industrial regulations, and that meets the
quality requirements as per ISO 9001:2008 as well as those of an
environment management system as per ISO 14001:2009.
An encoder is a device designed to be mounted in a system, and that
cannot be used independently of its intended function. For this reason,
an encoder is not equipped with immediate safety devices.
Considerations for the safety of personnel and systems must be provided
by the constructor of the system, as per statutory regulations.
By design, the encoder can only be operated within an EtherNet/IP
network. It is necessary to comply with the EtherNet/IP specifications and
guidelines for setting up a EtherNet/IP network.
In case of any other usage of, or modifications to the 842E-CM Integrated
Motion encoder, e.g., opening the housing during mounting and
electrical installation, or in case of modifications to the Rockwell
Automation software, any claims against Rockwell Automation under
warranty will be rendered void.
General Safety Notes and
Protective Measures
ATTENTION: Please observe the following procedures for correct and safe use
of the 842E-CM Integrated Motion encoder.
ATTENTION: The encoder is to be installed and maintained by trained and
qualified personnel with knowledge of electronics, precision mechanics and
control system programming. You must comply with the pertinent standards
covering the technical safety stipulations.
ATTENTION: All safety regulations are to be met by all persons who are
installing, operating or maintaining the device:
• The operating instructions must always be available and must always be
followed.
• Unqualified personnel are not allowed to be present in the vicinity of the
system during installation.
• The system is to be installed in accordance with all applicable safety
regulations and the mounting instructions.
• All work safety regulations of the applicable countries are to be followed during
installation.
• Failure to follow all applicable health and safety regulations may result in
personal injury or damage to the system.
• The current and voltage sources in the encoder are designed in accordance with
all applicable technical regulations.