Install the powermonitor 3000 unit, Mounting considerations – Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 Master Module Installation Instructions User Manual
Page 12
12 Powermonitor 3000 Master Module
Publication 1404-IN007F-EN-P - November 2009
Install the Powermonitor 3000 Unit
Only qualified personnel should install, wire, service, and maintain this equipment. Refer to
and follow the safety guidelines and pay attention to all warnings and notices in these
instructions.
for mounting hole dimensions.
Mount the master module with four No. 8-32 UNC or M4 screws with flat washers and lock
washers.
Mounting Considerations
Mount the Powermonitor 3000 master module in a suitable protective enclosure. Select an
enclosure that protects the master module from atmospheric contaminants, such as oil, water,
moisture, dust corrosive vapors and other harmful airborne substances. The enclosure should
also protect against personal contact with energized circuits.
The ambient temperature within the enclosure must remain within the limits listed in the
Specifications,
Select an enclosure that provides adequate clearance for ventilation and wiring for the power
monitor and other equipment to be installed within the enclosure.
for dimensions and spacing guidelines for the power
monitor.
When installed within a substation or switchgear lineup, we recommend that the power
monitor be mounted within a low-voltage cubicle, isolated from medium- and high-voltage
circuits.
ATTENTION
Electrostatic discharge can damage integrated circuits or semiconductors. Follow these
guidelines when you handle the module:
• Touch a grounded object to discharge static potential.
• Wear an approved wrist strap grounding device.
• Do not open the module or attempt to service internal components.
• Use a static safe work station, if available.
• Keep the module in its static shield bag when not in use.