Rockwell Automation 1404-M4_M5_M6_M8 Powermonitor 3000 Master Module Installation Instructions - Manual (Page 53)

Powermonitor 3000 Master Module 53
Publication 1404-IN007F-EN-P - November 2009
Refer to the Powermonitor 3000 Unit User Manual, publication 1404-UM001 , for
information on using the display module.
Calibration
To meet general operating requirements, regular recalibration is not necessary.
For special customer requirements, contact your local Rockwell Automation representative
for calibration or service information.
DMSTA Displays the display-module status bitfield as a hex number. A non-zero value
may indicate an anomaly, although a non-zero value may appear if a display
module is connected to an operating master module.
DM FRN Indicates the display-module firmware revision.
MM/DD/YYYY Displays the current date.
HH/MM/SS
Displays the current time.
RELAY Shows the status of the Form 4C relay.
KYZ Shows the status of the KYZ output.
S1 STATUS Shows the status of Status Input 1.
S1 COUNT Shows the accumulated value of Status Input 1 counter, since last cleared.
S2 STATUS Shows the status of Status Input 2, since last cleared.
S2 COUNT Shows the accumulated value of Status Input 2 counter.
OUTWD Displays the output word bitfield as a hex number.
Display Module Status
Display Description