Rockwell Automation 1305 AC Drive, Firmware 1.01-3.00 User Manual - Manual (Page 69)

5 Chapter Programming
5-1
CHAPTER OBJECTIVES
Chapter 5 describes all parameters for Bulletin 1305 drives.
Parameters are divided into groups for ease of programming
and operator access. Grouping replaces a sequentially
numerical parameter list with functional parameter groups that
increases operator efficiency and helps to reduce programming
time. For most applications, this means simplicity at startup
with minimum drive tuning.
CHAPTER CONVENTIONS
1. All parameters required for any given drive function will be
contained within a group, eliminating the need to change
groups to complete a function.
2. To help differentiate parameter names and display text from
other text in this manual, the following conventions will be
used – Parameter Names will appear in [Brackets] – Display
Text will appear in ‘‘Quotes.”
3. Parameter information in this chapter is presented for users
who have a Human Interface Module (HIM) installed. For
those users without a HIM installed, the drive can be
operated using the factory default values for each parameter
or parameter values can be changed through the serial port.
FUNCTION INDEX
The Function Index shown provides a directory of various drive
functions. The Page Number will direct you to the parameters
associated with each function.
Function
Accel/Decel Time
Accel/Decel Selection
Analog Invert
Auto Restart/
Run On Power Up
Current Limiting
Custom Volts/Hz
DC Boost
DC Brake-to-Stop
Fan/Pump Volts/Hz
Fault Buffer History
Frequency Select
Freq. Source Selection
Line Loss Fault
Minimum/Maximum Freq.
Page #
5-8
5-25
5-20
5-29
5-11, 5-13
5-16
5-16, 5-17,
5-18
5-21, 5-22
5-17
5-35
5-25, 5-23
5-25
5-35
5-10
Function
MOP
Motor Unbalance
Output Configuration
Overload Protection
Preset Frequencies
Process Display
PWM Freq. Derating
Ramp to Stop
S-Curve Acceleration
Skip Frequencies
Standard Boost V/Hz
Standard Volts/Hz
Start/Run Boost
Page #
5-6, 5-28,
5-44, 5-48
5-32
5-33
5-12
5-23, 5-25, 5-26
5-51
5-19
5-19
5-21,
5-25, 5-25
5-17
5-17
5-15
PARAMETER FLOW CHART
The chart provided on pages 5-2 and 5-3 highlights each group of
parameters and lists all parameters for each of the 13 groups. Parameters
that appear in more than one group are shown in bold. Parameter
numbers are shown in parenthesis immediately after the parameter name.
An example of how to program a parameter is shown on page 5-4.
PARAMETER FLOW CHART