Rockwell Automation 1305 AC Drive, Firmware 1.01-3.00 User Manual - Manual (Page 75)

Chapter 5 – Programming
5-7
Metering Group (cont.)
[Drive Temp] Parameter # 70 Factory Default None [Drive Temp]
Parameter Type Read Only Minimum 0
This parameter displays the drive internal temperature. Units 1 _C Maximum Not Applicable
[Last Fault] Parameter # 4 Factory Default None [Last Fault]
Parameter Type Read Only Minimum 0
This parameter displays the fault code for the present drive
fault. If there is no active fault, the value will be zero. Units Numeric Maximum Max. Fault Number
[% Output Power] Parameter # 3 Factory Default None [% Output Power]
Parameter Type Read Only Minimum 0 %
This parameter displays the percent of drive rated output
power. Units 1 % Maximum 200% Drive Rated
Power
[% Output Curr] Parameter # 2 Factory Default None [% Output Curr]
Parameter Type Read Only Minimum 0 %
This parameter displays the percent of drive rated output
current. Units 1 % Maximum 200% of Rated Drive
Output Current