Rockwell Automation 1784-PCC ControlNet Communication Card Installation Instructions - Manual (Page 26)

3-6 Install and Use the 1784-PCC Card in Windows 2000/XP
Publication 1784-IN034D-EN-P - June 2002
At this point you need to select where the file is located.
4. Select one of the following checkboxes:
•Floppy disk drives if you are going to use the floppy that ships with
the 1784-PCC card
•CD-ROM drives if you are going to get the file from the RSLinx
CD-ROM
•Specify a location if you downloaded the driver file from
www.ab.com.
5. If you select the Specify a location radio button in Step 4, Windows
2000/XP will prompt you to provide a location for the driver, as shown
below:
Type the location of the Windows 2000/XP driver and click Ok.
Table 3.C
If you select: Then:
Floppy disk drives insert the PnP drivers disk into the drive and click Next.
Windows 2000/XP will search for the appropriate
driver. Continue with Step 6.
CD-ROM drives insert the RSLinx CD into the drive and click Next.
Windows 2000/XP will search for the appropriate
driver. Continue with Step 6.
Specify a location use this selection if you have downloaded the driver
from www.ab.com. You will be prompted for the
location path of the driver. Click Next and Continue
with Step 5.