Rockwell Automation 1784-PCC ControlNet Communication Card Installation Instructions - Manual (Page 81)

Install and Use the 1784-PCC Card in Windows 95/98/Me 5-13
Publication 1784-IN034D-EN-P - June 2002
9. If there are conflicts, you may need to alter the settings of devices involved
in the conflict to get the 1784-PCC card to function properly.
Try unchecking the Use automatic settings box and then changing the
conflicting I/O, interrupt, or memory resources.
If there are no conflicts, continue with the following steps.
10. Return to the Device Manager and scroll through the list to find PCMCIA
sockets.
11. Double-click PCMCIA sockets to expand it.
12. Click on the PCMCIA controller used by your system.
13. Click Properties. Verify that the socket controller is enabled in the hardware
profile you are using.
IMPORTANT
The option of unchecking the Use automatic settings box is
Not always available in Windows 98. It depends on how the
operating system was installed and configured.
If Then
the device status says, “This device
is not present, not working
properly, or does not have all
drivers installed, code 10.”
• click the Resources tab and check the Conflicting Device list for
possible hardware conflicts; or you may want to verify that the
Use Automatic Settings option is enabled.
• you may have a general PCMCIA problem. You should contact
your computer manufacturer for a resolution.