Rockwell Automation 1784-PCC ControlNet Communication Card Installation Instructions - Manual (Page 55)

Install and Use the 1784-PCC Card in Windows NT 4-5
Publication 1784-IN034D-EN-P - June 2002
Locate the 1784-PCC Driver for Windows NT
When you install drivers for your operating systems, you must be certain to install
the correct files. Windows NT systems require an NT Driver. Refer to the table
below to be sure you are installing the correct driver files.
Install the 1784-PCC Driver
Follow the procedure below to install the Windows NT driver for the 1784-PCC/B
card.
1. Start the install process with your machine off.
ATTENTION
!
Failure to install the correct driver files could result in
unpredictable system operation.
Table 4.B
Source (where the
driver is loaded
from) Driver location (for Windows NT operating systems)
installation disk,
version 1.6
1 or later
(shipped with the
1784-PCC card)
A:\setup.exe
A:\Unpccnt.exe
A:\pcc_config.exe
where
A:\ is the floppy drive letter
internet www.ab.com/support/products/pccards.html
You can also access Rockwell Automation Knowledge documents
at this site.
1 If your installation disk is earlier than version 1.6, we recommend downloading the latest
version from www.ab.com/support/products/pccards.html.
IMPORTANT
You are required to insert the 1784-PCC card in order for the
installation to work properly. We recommend that you insert the
1784-PCC card only when your system is not powered. Once you
have installed the driver and you insert the 1784-PCC card into
the slot, we do not recommend that you remove the 1784-PCC
card while Windows NT is running.