Rockwell Automation 1772-LV Mini-PLC - 2/15 Programmable Controller (Series B) Programming and Operations - Manual (Page 104)

Chapter
8
8Ć1
Programming Fundamental Instructions
This chapter shows how to program the fundamental instructions.
In this chapter you will read how to:
Enter rungs using relay type instructions.
Insert an instruction into an existing rung.
Remove an instruction from an existing rung.
Edit an existing rung.
Power up your industrial terminal by turning the ON/OFF switch clockwise.
The switch is located to the right of the screen (Figure 8.1).
Figure 8.1
Industrial Terminal
10697ĆI
After a short while, the following display will appear:
Figure 8.2 illustrates the screen’s display which you will see before you begin to
insert your program. Press the keys 11 to start programming.
NOTE: The processor mode select switch must be in the PROG keyswitch
position before you are able to insert your program.
Now you are able to insert your program. Proceed to section A.
Objectives
System Start Up